TILE NIPPERS- STRAIGHT
$18.18
Description
Drop Forged
Tungsten Tip
Cuts clean straight sections in tiles
Drop Forged
Tungsten Tip
Cuts clean straight sections in tiles
NEW SOUTH WALES
Opportunities in stocking or distribution – contact info@lev-tec.com.au
QUEENSLAND
Opportunities in stocking or distribution – contact info@lev-tec.com.au
VICTORIA
Opportunities in stocking or distribution – contact info@lev-tec.com.au
TASMANIA
Opportunities in stocking or distribution – contact info@lev-tec.com.au
SOUTH AUSTRALIA
Opportunities in stocking or distribution – contact info@lev-tec.com.au
NORTHERN TERRITORY
Opportunities in stocking or distribution – contact info@lev-tec.com.au
WESTERN AUSTRALIA
Opportunities in stocking or distribution – contact info@lev-tec.com.au
AUSTRALIAN CAPITAL TERRITORY
Opportunities in stocking or distribution – contact info@lev-tec.com.au
Opportunities in stocking or distribution
To find out more about the LEVTEC Tile Levelling System advantages contact us.
LEVTEC Tile Levelling Systems are designed to create flawless tiling projects efficiently every time.
LEVTEC allows you to set floor and wall tiles in a way that will hold the tiles unique without lippage until the adhesive dries. This process is extremely accurate and efficient at achieving a faultless surface.
We, as tilers, are aware of the challenges when installing certain projects. With LEVTEC tile levelling systems these worries are behind us as the interlocking design holds the tiles together till setting, eliminating the effects of glue shrinkage, gravity and slight substrate imperfections affecting the desired finish of your floor or wall project.
Spread your tile adhesive and lay the tile. Place LEVTEC clips underneath the tile slightly back from the edge.
Keep the LEVTEC clip firm against the tile as the clip acts as a 1.5mm spacer.
Set the adjacent tile firmly into the adhesive. Butt the tile against the LEVTEC clip giving the 1.5mm joint (if a larger joint is required spacers can be used, or set the required joint size).
Slide the LEVTEC wedges through the LEVTEC clips until they are firmly levelling both tiles.
Using your thumb, push the LEVTEC wedge with the right amount of pressure required to create the perfect finish.
Once the tiles are locked in position this is how they will stay until the adhesive sets. You can still slightly adjust the joint width while the adhesive is setting if needed without disrupting the height of the tiles.
After the adhesive has set, you can remove the LEVTEC wedges and clips easily with a rubber mallet on the walls and by mallet or your foot on the floor.
Hit the LEVTEC clip on its side lug in the direction of the tile joint and the wedge and clip will dislodge from the tile at the breakpoint below the tile, leaving the joint free for grouting or silicone expansion.